Question What Voltage 
Answer All Wallas equipment requires 12 volts D.C.

Question Does a Wallas supply via an RCD panel  
Answer NEVER Wallas hobs and ovens Require direct fused connection to 12 Volt battery.

Question Do Wallas require a pump 
Answer NO, they have built in pumps

Question Does fuel supply require a filter     
 Answer yes they have an in line filter fitted

Question from where in the fuel tank can the fuel be fed from

Answer Preferably from its own outlet from the bottom of the tank with an accessible isolation valve, however it maybe fed from a Wallas special dip tube which is fitted through top of tank,

Question How long can the fuel line be and what size of pipe?

Answer It is recommended the pipe be 5mm OD and 2mm ID for British waterways copper pipe 1/8” (3mm) is required, maximum length is 8 metres

Question Can I run both hob and oven from one single fuel line from the tank?

AnswerYes, however depending on the vessel and position of the tank special requirements may apply.

Question what are these requirements?

Answer When ever the fuel tank maximum level is higher than the Wallas device  a fuel solenoid valve is required in the fuel line.

Question What if I have both a hob and an oven on my fuel line in the above case?

Answer One would fit a relay kit which would operate the fuel solenoid valve whenever any  One (or both) of the units was switched on

Question How does one wire up a relay kit to hob and oven?

Answer  Go to www.kuranda.co.uk and down load procedure to do this.

Question Does a single fuel solenoid valve work on more than two devices

Answer NO, it will work on two devices with a relay kit, however for any more devices, another solenoid valve will be required

Question How many Wallas devices can I fit to one fuel line

Answer One (combined) unit is generally fitted to one Wallas supplied fuel line,