12-12V Voltage Stabilizer
Product Code: DDI12-12
£79.12
Ex Tax: £65.93

Qty

Ask About This Product

12-12V Voltage Stabilizer for continuous use at 3A.

product fit onto a ‘Click ‘n’ fit’ mounting clip which is fixed in three points allowing it to be mounted on uneven surfaces. It is easy to fit the clip into awkward places, then simply click the unit into position. A red LED indicates when there is output from the converter. This gives reassurance to the installation engineer and speeds fault finding.

 

Input voltage range 12Vdc, 24Vdc and 48Vdc +/- 30%
Output voltage 13.6Vdc or 27.2Vdc +15% -20% at extremes of temperature, load, input tolerance, etc.
Intermittent output power Continuous rating +25%, taken for a maximum f 2 minutes followed by 8 minutes rest.
Transient voltage protection Meets !SO7637-2 International standard for 24Vdc commercial vehicles
Electrostatic voltage protection Meets ISO10605, ISO14892, >8kV contact, 15kV discharge
Output noise <50mV pk-pk (100mV on 24V units) at continuous load. Meets CISPR25 and VDE0879-3
Off load current (quiescent current) <100mA
Power conversion efficiency Typically: 90% for non-isolated units, 85% for isolated units
Isolation >400Vrms between input, output and case, on isolated products only
Operating temperature -25ºC to +30ºC to meet this specification table -30ºC to +80ºC de rate linearly to 0A
Storage temperature -25 ºC to +100ºC
Operating humidity 95% max., non-condensing
Casework Anodised aluminium, glass filled polycarbonate, dust water and impact resistance to IP533 (excludes DDi 24-24 240 which is ventilated and fitted with a cooling fan)
Connections Four 6.3mm push-on flat blade connectors
Output indicator Red LED adjacent to output terminals
Mounting method ‘ Click ‘n’ fit mounting clip, fitted separately using three hole fixing
Safe area protection: Over current Limited by current sensing circuit
Over heat Limited by temperature sensing circuit
Transients Protected by filters and rugged component selection
Catastrophic failure Protected by internal input and output fuses
Approvals

2004/108/EC The general EMC directive

2006/96/EC The automotive directive

93/68/EEC The CE marking directive

Markings CE and e marked

 

Flexible led strip lights require a constant voltage of no higher than 12v. These must be used unless you use a plugin power supply unit.

 

Related Products
Latest Products